WOMA(wuxi) environmental protection equipment Co.,Ltd

High quality product, professional service, being the core supplier in air floatation and sewage treatment equipment!

Home > Exhibition > Content
The operation characteristics and maintenance of the sludge scraping and sucking machine
- Oct 24, 2017 -

The sludge scraping and sucking machine is mainly used for sewage treatment plant. The horizontal flow sedimentation tank of the waterworks settles the sludge from the bottom of the tank to the suction mouth of the pump through the pump suction line. The sludge scraping and sucking machine is used to remove the sludge from the bottom of the tank, and the sludge from the bottom of the tank can be removed.

 

The sludge scraping and sucking machine mainly adopts the truss structure, which will be much lighter than the traditional structure weight. It can be used by the hot dip galvanizing anticorrosion process, so as to ensure no corrosion in five years. The components which contact with water use 304 stainless steel and the service life is greatly lengthened.

 

The maintenance of the sludge scraping and sucking machine in ordinary working process is relatively small. The whole equipment will be equipped with the low power and operation cost. The whole equipment selects the reasonable pump and stable operation. The new transmission mechanism can avoid the walking error of the two sides when using.

 

The road wheel of the sludge scraping and sucking machine ensures the service life. The equipment is mainly composed of four - point supported walking beams across the horizontal flow sedimentation tank and bilateral drive. The rail runs from one end of the pool to the other end of the pool, while at the same time, it sucks the sludge. Bump the stroke control, return to walk, take suction back and complete a working cycle.

 

In order to facilitate the normal operation of the sludge scraping and sucking machine, the four walking wheels must be made on two parallel sides of the rectangle during installation. The rail steel must be on the two sides of the rectangle and on the same horizontal plane. On both sidewall roof of the horizontal flow sedimentation tank, the embedded iron is reserved on the rail steel, and one iron for each one meter. Each embedded iron is made of bolts and plates on both ends so that the rail can be compressed.


WOMA(wuxi) environmental protection equipment Co.,Ltd.

Address:Xishan district Wuxi City Jiangsu Province Tin Beizhen Union Village Industrial Park

Contact: FengQihui

Tel:+86-510-8378-0898

Fax:+86-510-8378-0898

Phone:+86-18806179670

Email:616165253@qq.com

Website: http://www.air-floatation.com