The standardized module design of the horizontal three phase separator is suitable for installation. The efficiency of the whole equipment is set, the cutting rate is high, the air tightness is good, the gap width and the covering width of the horizontal three-phase separator are arranged reasonably, and no sludge is lost; The quick-opening scum cleaning device ensures that the air outlet pipe is unobstructed and will not be blocked.

The horizontal three-phase separator has a fast starting speed and does not have its phenomenon of current interruption, flow, etc. The energy consumption of the whole equipment is low and the biogas can be collected and utilized. The equipment adopts a new material different from the material of the traditional three-phase separator, saving Cost, quality and price.

The inclined angle of the inclined wall of the horizontal three-phase separator and the horizontal inclination angle is 50&, so that the sludge deposited on the inclined plate does not gather and stay, and can slide back to the reaction zone as soon as possible. This angle also determines the height of the three-phase separator. This height is generally 0.5 to 1.0 m.

The horizontal three phase separator should make the biogas bubbles not enter the sedimentation zone as much as possible to affect the sedimentation effect. The shielding between the reflector and the gap should be 100-200mm, and the area of the gap of the gas-collecting chamber accounts for 15%-20% of the total reactor area.

http://www.air-floatation.com/