WOMA(wuxi) environmental protection equipment Co.,Ltd

High quality product, professional service, being the core supplier in air floatation and sewage treatment equipment!

Home > Exhibition > Content
Centre Drive Mud Scraper Installation and Operation Instructions
- Apr 24, 2018 -

In the process of installing the centre drive mud scraper, it is necessary to ensure the rationality of the installation of various components, and after the installation, it is necessary to check again and confirm it is correct, which can ensure the normal use in the later period. After the installation is completed, it is also necessary to add lubricating oil to the center drive scraper in time.

 

Remember, it is necessary to add the appropriate amount of lubricant according to the instructions of the centre drive mud scraper. In addition, prior to starting the equipment, it is also necessary to carry out corresponding inspections, especially paying attention to whether the wiring of the electric control box is correct and whether the moving part has phase interference. After the inspection is correct, the trial run can be carried out.

 

During the drive of the center scraper, the first thing to do is to check its lifting function. Generally during the lifting test, there must be a person near the center of the bottom of the sedimentation tank. When lifting, the stirring sub-tank in the mud bucket must not interfere with the underwater bearing when it is raised to the highest position. If the interference can be changed, Underwater bearings to solve the level.

 

It should be noted that, under normal circumstances, the center drive scraper should maintain a good operating state during operation, no abnormal vibration, no abnormal noise, no abnormal temperature rise, oil flow, smooth operation.

 

As a worker, during the operation of the centre drive mud scraper, it is necessary to pay attention to its operating status. If an unexpected situation occurs suddenly, such as the scraper's torque exceeds the set value, the safety pin mounted on the gear will be cut off and the motor will idle. At that time, it is necessary to find out the reason for the cut-off of the insurance sales, lift the scraper, remove the fault and replace it with a new one, and the thickener can operate normally.

 

In addition, during the operation of the center drive scraper, it is also necessary to observe whether the transmission mechanism is abnormal. In short, during the operation of the central transmission scraper, effective measures should be taken in time to make it work properly.

 

http://www.air-floatation.com/